Generally you want to use a hard pad with solid surface and back then the RO90DX hard pads were on back-order. When I took the Solid Surface class in early 2011 the RO90DX had not yet been released in the USA, but we did try them. My experience is the OF2200 vibrates less than the OF1400. ![]() ![]() Perhaps an OF1400 would also have worked, but solid surface material is best worked with a minimum of vibration. In the class I used the OF2200 because that is my go-to router for most edge treatment. Generally that is sold about 12mm thick, so a TS55 has more than enough power. Steve has almost 30 years of experience with it and his class is well worth the money.Īre you planning to laminate countertops or do solid surface fabrication?ĭuring the Solid Surface Fabrication class taught by Steve Base at the Festool Henderson, NV facility we used the plastic Aluminum blade to saw the solid surface material. I strongly recommend taking Festool's Solid Surface class with Steve Bace in Henderson, NV, if you get the opportunity. You can't have too many spring clamps that will span 2". When you get into fabrication and joining multiple sheets of solid surface material, you'll need some Bessey PS-55 clamps to hold the pieces together as the adhesive sets up. I like Festool, Whiteside and Amana router bits. Most any good router bit will help you get the profile you want. Be aware that there are specific techniques for using the abrasives to get the finish you want. The Festool buffing and polishing compounds will bring out a high-gloss finish quite well. Either the RO 125 or RO 150 will do very well for surface polishing when using Granat and Platin (for the higher gloss finishes). ![]() The standard TS 55 blade works well, but the Solid Surface / Laminate 48-Tooth Saw Blade (496309) will likely work better. Brian, you already have a decent selection of Festool goodies that will work well for solid surface material.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |